ProbeBasic backplot issue?

One thing you probably want to change is the following line in your ini file:INCREMENTS = .1in .05in .01in .005in .001in .0005in .0001in

To
INCREMENTS = JOG .01in .001in .0001in

What mpg are you using? And are you using an atc?

I haven't started tackling the JOG yet - except that I have turned on keyboard jogging (which didn't work properly with the VTK error). Jogging is probably next - and cutting the control panel. I am using an ATC, I think I have the toolchange pretty well worked out now. For an MPG I'm using a generic 100ppr mpg, and I have 3 encoders for spindle, rapid, and feedrate overrides. I haven't started tackling those on the machine yet.

your config file had alot of configurations for things not being used then it seems
you may want to clean things out to the bare minimum and add back in one piece at a time. having so many unused configuration bits can cause a plethora of headaches and conflicts.

Hello, 
when I start the probe_basic_lathe simulation and change the view, I get an error in the file vtk_backplot.py. 
I have installed the latest LCNC 2.9 ISO.

Anton wrote:

Hello, 
when I start the probe_basic_lathe simulation and change the view, I get an error in the file vtk_backplot.py. 
I have installed the latest LCNC 2.9 ISO.

i can verify, taking a look! thanks for the report!

Error when trying to open a standard pawn turning file. This error appears only in the turning configuration.
In the milling configuration, there are no problems when starting 3D_Chips.ngc.  Pls, help me.
Debian 12.6 + linuxcnc 2.9.3 from .deb install + probe basic apt install