Probe Basic M6G43 (m6_tool_call_tool_page) not working

Hello everyone

I am a little lost here. I am moving my machine interface to probe basic. Most things work already, however when I press M6G43 and other commands which call for the subroutine "m6_tool_call_tool_page.ngc", nothing happens. GO TO ZERO or GO TO G30 do work.

If I look at the terminal I get the following:

And thats it. The machine is stuck there. I have attached my full config. Any input is greatly appreciated.

Greetings
Sandro
 

Okay attaching the config did not work. Second try

missing this line in your main hal under the tool change signals it looks like:

# ---ignore tool prepare requests---
net tool-prepare-loopback iocontrol.0.tool-prepare => iocontrol.0.tool-prepared

This works! Thank you very much! I totally overlooked it in the documentation and actually removed it from my old configuration.

Is there a way, that a tool touch off is automatically performed on every tool change?

You would add that in to an m6 remap, see the probe basic atc sim for an example of remap.