Homing and Unhoming Actions

Nearly...

It now attempts to load the panel, the panel appears on screen but I get this:
This is the load line I used:
If I remove the "W" then it loads fully but I notice that the component name is sim/qtplasmac.sim rather than qtplasmac_sim.
I have attached the two panel files plus the hal file.

ok i pushed a fix for that but:

don't use -u , qtvcp expects the handler file is either in an installed folder or the same place as the ui file. I'll look at the -u code in future, if required (or remove it)

loadusr -Wn qtplasmac_sim qtvcp sim/qtplasmac_sim.ui

Should work fine.
If you want a different HAL component base name then use -c:

loadusr -Wn sim_test qtvcp -c sim_test sim/qtplasmac_sim.ui