Widgets Mdi Touchy

More
5 years 10 months ago #191322 by hottabich
Widgets Mdi Touchy was created by hottabich
After Linuxcnc updates, when adding the Mdi Touchy widget to QtDragon, Dro A does not work. Please tell me how to fix it. Thank you!

Please Log in to join the conversation.

More
5 years 10 months ago #191332 by cmorley
Replied by cmorley on topic Widgets Mdi Touchy
Could be related to this?

forum.linuxcnc.org/qtvcp/40656-dro-not-counting-for-joint-4

Please Log in to join the conversation.

More
5 years 10 months ago #191357 by hottabich
Replied by hottabich on topic Widgets Mdi Touchy
Thanks for attention. But without the widget, Dro-A counts. It all started after changing the speed sliders.
If the A axis is number 4 then the mm-inch dimension is switched.

Please Log in to join the conversation.

More
5 years 10 months ago #191367 by cmorley
Replied by cmorley on topic Widgets Mdi Touchy
you working in 2.8?

Please Log in to join the conversation.

More
5 years 10 months ago #191368 by cmorley
Replied by cmorley on topic Widgets Mdi Touchy
also which sim from your attachment are you testing with?

Please Log in to join the conversation.

More
5 years 10 months ago #191387 by hottabich
Replied by hottabich on topic Widgets Mdi Touchy
I am using Linuxcnc 2.8 as in the screenshot. Simka with 2.8 and mine, if you remove the mdi touchy widget, work the same way.

Please Log in to join the conversation.

More
5 years 10 months ago #191392 by cmorley
Replied by cmorley on topic Widgets Mdi Touchy
I can't duplicate the problem.

I do see you have an error related to the resource file but I'm not sure that's related.

Please Log in to join the conversation.

More
5 years 10 months ago #191403 by hottabich
Replied by hottabich on topic Widgets Mdi Touchy
Why is the mdi touchy widget breaking the A axis? No problem without a widget. Please upload the config and you will see what I am asking. The second config is the same but without the widget.

Please Log in to join the conversation.

More
5 years 10 months ago #191434 by cmorley
Replied by cmorley on topic Widgets Mdi Touchy
In my test - both seem to work fine.
Are you using 2.8.1?

Are you sure linuxcnc is running the .ui file you think it is?
You can check the output in the terminal to confirm what .ui and handler it's using.

Chris

Please Log in to join the conversation.

More
5 years 10 months ago #191445 by hottabich
Replied by hottabich on topic Widgets Mdi Touchy
Without the widget, the commands G20, G21 change the bit width of the A axis dro, but with the widget they do not. I believe the two decimal places are correct and should not change in the designer's opinion. Axis A is practically working. Maybe I'm wrong. Thanks for attention.

Please Log in to join the conversation.

Time to create page: 0.087 seconds
Powered by Kunena Forum