Error in tool_offsetview.py

If it's a lot of unfun work, I've not been asked by anyone about it.
It can wait for Jim's newest version, that will be in master.
I'll try to get to other changes soon.

Thank you.

It's a lot of work, but if there is interest, I can of course work on it.

Meanwhile, I made a new status bar to make it look good, this required minor modifications to the handler file. I tested it, everything works, but it will be nice if someone else tests it on a full HD screen.

pushed - had to fix some paths in the .ui file /user/marko got in there...

Chris

need to delete the resource file your configuration folder/qtvcp to see the new A buttons

There is a problem with starting qtdragon. with qtdragon_hd there is no problem.
I don't see anything changed in the handling file, but there is a problem with the self.factor value. I checked on two systems.

 

Can you run from a terminal and see if there is other info. That's not the true error.

If I comment out self.factor, qtdragon will start normally, but then of course the "rapid iverride" value is displayed incorrectly.

Another change I noticed is that after starting qtdragon, all speed setting sliders are set to zero.

I promise, the self.factor is not the real problem.

Looks like emc motion module failed to load.
Master had some work pushed lately that creates race conditions.
I bet this is related.
I believe Rene has got a tested fix.

github.com/LinuxCNC/linuxcnc/commit/7ebe...mitcomment-128862189

Someone asked for it from the forum, so I corrected the qtdragon_hd themes because the 4th and 5th axis looked bad. I also enlarged the macro buttons vertically and made minor corrections to the status bar at the bottom of the window.


As for the error I wrote about in the previous post, I agree that it is not qtdragon's problem, when I press "retry", qtdragon starts, apparently it lacks access to some pins and needs a little delay. In qtdragon_hd this error does not occur because the service file has the declared value "self.factor = 1.0" at the beginning, but after running all 4 sliders are set to zero, in qtdragon only 2 sliders are set to zero, as in the screenshot .

done
In metal, I adjusted the groupbox title to mimic colored_metal.
I fixed the jog button's property joint_number - it should be -1 for all buttons.
-1 means convert the axis letter to joint number

Chris