home_all Cannot jog move after

More
4 years 7 months ago #237865 by yi2580
home_all Cannot jog move after was created by yi2580
I have another new question. I'm at home_all Why can't jog motion after , but it can MDI motion or load G code motion. And at home_all Before , it could jog move. I hope someone can have a good solution. Thank you very much

Please Log in to join the conversation.

More
4 years 7 months ago #237869 by cmorley
Replied by cmorley on topic home_all Cannot jog move after
Just a guess...after homing you must jog axes not joints

Please Log in to join the conversation.

More
4 years 7 months ago #237878 by yi2580
Replied by yi2580 on topic home_all Cannot jog move after
Then how should I jog axes?

Please Log in to join the conversation.

More
4 years 7 months ago #237880 by tommylight
Replied by tommylight on topic home_all Cannot jog move after
Does the DRO change to world mode after homing?

Please Log in to join the conversation.

More
4 years 7 months ago #237910 by cmorley
Replied by cmorley on topic home_all Cannot jog move after

Then how should I jog axes?
 
I need way more information about how and with what you are trying this with, to attempt a reasonable answer.

Please Log in to join the conversation.

More
4 years 7 months ago #237911 by snowgoer540
Replied by snowgoer540 on topic home_all Cannot jog move after
What screen are you using?

Please Log in to join the conversation.

More
4 years 7 months ago #237990 by yi2580
Replied by yi2580 on topic home_all Cannot jog move after
I use qtvcp (pyqt5) and program some Python interfaces myself

Please Log in to join the conversation.

More
4 years 7 months ago #238170 by andypugh
Replied by andypugh on topic home_all Cannot jog move after
You need to jog joints before hoiming and axes after.

For HAL-based jogging this generally looks like

net x-jog-plus joint.0.jog-plus axis.x.jog-plus

(and so on)

ie, you gnerally need to drive both so that joggin eorks regardless of mode.

Please Log in to join the conversation.

Time to create page: 0.094 seconds
Powered by Kunena Forum