How to enable wait for spindle-at-speed in QTDragon

More
4 years 1 month ago #252247 by kas1kas
Replied by kas1kas on topic How to enable wait for spindle-at-speed in QTDragon
lsb_release -sa: Debian Debian GNU/Linux 10 (buster) 10 buster
LINUXCNC - 2.9.0-pre0-7591-ga7fc80b3a

Please Log in to join the conversation.

More
4 years 1 month ago #252258 by cmorley
Replied by cmorley on topic How to enable wait for spindle-at-speed in QTDragon
I'll tell you here. I'm just very busy at work right now so have limited time.

Please Log in to join the conversation.

More
4 years 1 month ago #252284 by kas1kas
Replied by kas1kas on topic How to enable wait for spindle-at-speed in QTDragon
No problem! Something for another day. Thanks for the support.

Please Log in to join the conversation.

More
4 years 1 month ago #252374 by cmorley
Replied by cmorley on topic How to enable wait for spindle-at-speed in QTDragon
ok on your next update, there should be an output HAL pin called 'qtdragon.spindle-is-at-speed'
It uses qtvcp's internal calculation for at-speed. +- 10% by default

Chris

Please Log in to join the conversation.

More
4 years 1 month ago #252385 by kas1kas
Replied by kas1kas on topic How to enable wait for spindle-at-speed in QTDragon
Thanks already Chris.
That makes it so much easier for new installs!
regards, Kas

Please Log in to join the conversation.

Time to create page: 3.544 seconds
Powered by Kunena Forum