MDI calls from qtvcp

thank you for your responses. the actions from qtvcp are based on the actions of linuxcnc.py and inherit all of its problems and even multiply them in some cases. in view of which the actions from qtvcp do not simplify the task in any way.

the code that I need to execute is just "G0X2000Y6000" so that the portal goes to the end of the working field

You'll have to give specifics why the action library doesn't work for you. it is specifically made to make things easier, consistent and future proof.

Your code example does more then call an MDI code.ACTION.CALL_MDI('G0 X2000 Y6000')
should set linuxcnc into MDI mode if it is not and then run the command to the end without blocking.

phillc54 wrote:

You could try something like this:

Code:

ACTION.CALL_MDI('G0 X2000 Y6000') while not STATUS.is_interp_idle(): self.w.gcodegraphics.updateGL()     QApplication.processEvents()

You are the best!