Here you go. Thanks for looking into it.
From what I can see you are running Bookworm. The last build of linuxcnc in it is back in about November. QTdragon/Versaprobe are still very new.
I think that has been fixed in later versions.
Now here is a secret short cut. Go here
buildbot2.highlab.com/
Follow your nose via the debs here link until you get to the list of debs.
You should end up here
buildbot2.highlab.com/debian/dists/bookw...uspace/binary-amd64/
Download the latest linuxcnc-uspace deb.
Currently this one but its an automated build system so it might change
linuxcnc-uspace_2.9.0~pre1.787.g913733ff1_amd64.deb
open a terminal in the downloads folder
1. Uninstall the current Linuxcnc package
2. Install the deb you downloaded
Code:
sudo apt remove linuxcnc-uspace
sudo dpkg -i linuxcnc-dev_(tab)
