qt_dragon_hd - manual tool change and remap

Oh, oh! I forgot my other question @cmorley...

what did you mean about "the new tool table" and having a tool offset?

Is that just the Z-offset?

Quick update, I couldn't finish tonight: it is getting back to the XY coordinates, but I forgot to accomodate the Z-offset that the toolsetter just calculated! So it's trying to go to the old G54 Z coordinate and I need to calculate the new one... it shouldn't be hard but things were waaay off (more than the difference in the new tool) so I was doing something else silly.

Hopefully I have it sorted by tomorrow, then I'll post here.

But as an additional question:

What is the purpose of this button? When I click it nothing happens. I thought it would have let me fill the tool table with the z-offset of the current tool by lowering it onto the toolsetter.

 

Thanks!

its not implemented yet, but yes it's for manual tool length probing.

To answer one of your other questions - type:
qtvcp
in the terminal and you will get two lists; of built in screens and built in panels