Its been ages since I fired up my mill so I may be a bit out of date with versions.
i wanted to find the centre of a 13mm hole.
I set the diameter hint to 13mm but it was erroring just before the second probe.
I eventually worked out I had the XY setting set to 10mm so changed it to 13.
I then got the hole centre located.
I wondered if ths limit should be considered when looking for a hole? Surely the diameter hint is all thats required?
It cost me a fair bit of time so others could easilly be confused.
Maybe its been fixed.
PS. The conversational facing worked pretty well too!
