Qtdragon ERROR INFO Probe routine: failed: Probe tripped during non-probe move.

Hello everyone,I'm experiencing a persistent issue with either BasicProbe or VersaProbe when running probe routines. Here’s a detailed description of the problem and what I've tried so far:Error Message:

• "ERROR INFO: Probe routine failed - Probe tripped during non-probe move."

Issue Details:

• The issue arises when I activate a probe routine. Initially, the axis starts moving as expected. However, as soon as the probe is activated, the routine stops and throws the error message noted above.

Troubleshooting Attempts:

1. Added debounce to the probe input — no change.
2. Increased debounce time to 1 second (1S) — still facing the same issue.

Additional Observation:

• The motors are moving in the opposite direction to what is expected when the probe routines are running.

Seeking Advice: Does anyone have insights or suggestions on what might be causing this issue or how to fix it? Any help would be greatly appreciated!Thanks in advance for your assistance!Best regards, Mikael

See the label 'motion type' in the probe tab?
See if it says 'Probe' when the probe trips.

If it says 'feed' then it's not expecting a probe trip.

Thanks cmorley, that was the problem. in combination with my feed being too slow, so it made timeout before ever going into probing.