Hi Guys,
I think I found a bug in the probe_routines.py for versa probe. When Trying to probe from outside from 4 sides in the current setup I was not able to make it working. ( I always had to probe very end X+ and Y+ with adequate searching distance). Not sure if this is happening only for me but but this was pretty anoying because even I found center I couldn't from ceter position run routine again to double check.
Someone might find this helpful i adjusted probe_routines.py file (/usr/lib/python3/dist-packages/qtvcp/widgets/probe_routines.py)
github.com/LinuxCNC/linuxcnc/blob/master...ts/probe_routines.py
line 1089
Code:
aa = (2 * self.data_side_edge_length) + self.data_latch_return_dist + self.data_xy_clearance
replace with:
Code:
aa = 2 * (self.data_side_edge_length + self.data_latch_return_dist + self.data_xy_clearance)
line 1054
Code:
aa = (2 * self.data_side_edge_length) + self.data_latch_return_dist + self.data_xy_clearance
replace with:
Code:
aa = 2 * (self.data_side_edge_length + self.data_latch_return_dist + self.data_xy_clearance)
