status time,

More
1 year 10 months ago #315745 by Kasper-001
status time, was created by Kasper-001
hey there,

i have this problem, that status time is not counting, 
im using fusion 360, it has been counting before

idk if it´s fusion or qtdragon

hope for some advise

merry christmas every one !
 

Please Log in to join the conversation.

More
1 year 10 months ago #315757 by cmorley
Replied by cmorley on topic status time,
What status time are you referring too?

Please Log in to join the conversation.

More
1 year 10 months ago #315825 by Kasper-001
Replied by Kasper-001 on topic status time,
sorry i mean run time

Please Log in to join the conversation.

More
1 year 10 months ago #315851 by cmorley
Replied by cmorley on topic status time,
What version of lubuxcnc are you using?
Are you using the screen button the start the program running?

Please Log in to join the conversation.

More
1 year 10 months ago #315906 by Kasper-001
Replied by Kasper-001 on topic status time,
linuxcnc 2.10
no using a hand control to start it, for the most of the times

Please Log in to join the conversation.

More
1 year 10 months ago #315928 by cmorley
Replied by cmorley on topic status time,
Please see if the timer works if you use the screen button to start the program.

Please Log in to join the conversation.

More
1 year 10 months ago #316206 by gardenweazel
Replied by gardenweazel on topic status time,
I noticed this recently as well, although I've not checked since. 

Please Log in to join the conversation.

Time to create page: 0.090 seconds
Powered by Kunena Forum