Captive nut, made on an EMCO 120P

tome
Topic Author
Offline
Premium Member

10 years 7 months ago #71011 by tome

Captive nut, made on an EMCO 120P was created by tome

This may be a right of passage. Or perhaps just a fun waste of time :laugh: . Made this captive nut on the EmcoTurn 120P today:
It came out better than I expected. In fact, it took me a couple minutes under a microscope to find the "trick", and I knew generally where it was!

Attachment not found

Please Log in to join the conversation.

cncbasher
Offline
Platinum Member

10 years 7 months ago #71018 by cncbasher

Replied by cncbasher on topic Captive nut, made on an EMCO 120P

nicely done !

Please Log in to join the conversation.

cmorley
Offline
Platinum Member

10 years 7 months ago #71077 by cmorley

Replied by cmorley on topic Captive nut, made on an EMCO 120P

What no pic of it undone?

Please Log in to join the conversation.

tome
Topic Author
Offline
Premium Member

10 years 7 months ago #71087 by tome

Replied by tome on topic Captive nut, made on an EMCO 120P

cmorley wrote: What no pic of it undone?

Did Houdini reveal his tricks? Did David Copperfield give his audience a picture if his methods? I think not. :-)

....

On the other hand, I am no magician

Attachment not found

And here is a video of it being opened:

Please Log in to join the conversation.

Time to create page: 0.187 seconds