Lathe using C axis mode making a synchronized pulley

Is not LinuxCNC amazing?

Ola EmcPt,
Yes it is, if only we had a link to watch it !

Oh the link is there.
Thank you.

I have the right hob for making T5 timing pulleys, so can do it this way:

In my case the pulley have a chamfered end that prevents the belt extrusion. That would be impossible to make (in one part) with the hub due to its radius. The orange is the teeth and they go up to the chamfer.

And by the way, removing the rod from the lathe, putting it on the mill will always go a bit of center.
Making all in one tight provides the best result.