DIY VMC

More
6 years 4 months ago #173127 by hadcom
Replied by hadcom on topic DIY VMC
I don't really know, about 7000€

Please Log in to join the conversation.

More
6 years 4 months ago #173128 by hadcom
Replied by hadcom on topic DIY VMC
No it is a chinese Spindle motor

Please Log in to join the conversation.

  • thefabricator03
  • New Member
  • New Member
More
6 years 4 months ago #173134 by thefabricator03
Replied by thefabricator03 on topic DIY VMC
Is there any shrinkage with the UHPC?

Please Log in to join the conversation.

More
6 years 2 months ago #177719 by hadcom
Replied by hadcom on topic DIY VMC
very little shrinkage

Please Log in to join the conversation.

More
5 years 9 months ago #195010 by TREFAB
Replied by TREFAB on topic DIY VMC
How do you like your spindle? Did you replace the HTD pulley or are you using it. Do you regularly run at 12000 RPM? I have one currently waiting to be installed.

Please Log in to join the conversation.

More
5 years 9 months ago #195074 by hadcom
Replied by hadcom on topic DIY VMC
I like it! i use the HTD pulley but since the begining it's badly trimmed so it vibrates at higher RPM's, i never runned at 12k rpm, max 6k5 because of the Servo motor that has only 8k

Please Log in to join the conversation.

Time to create page: 0.076 seconds
Powered by Kunena Forum