Plasma Linuxcnc finally running correctly

More
6 years 5 months ago #168347 by jay1st
Plasma Linuxcnc finally running correctly was created by jay1st
Finally i got it to run smoothly and correctly.

Solved my THC problems using a cheap pilot arc HF plasma cutter



Now i need to save some money to buy a serious plasma genrator!

Please Log in to join the conversation.

More
6 years 5 months ago #168415 by tommylight
Replied by tommylight on topic Plasma Linuxcnc finally running correctly
Nice to see it working properly.
Regards,
Tom.
P.S.
just noticed a typo on the subject, try to edit it and if it does not stick let me know, i will make it stick.

Please Log in to join the conversation.

More
6 years 5 months ago #168560 by jay1st
Replied by jay1st on topic Plasma Linuxcnc finally running correctly
i cant change it :)

and the other topic as well, as it's more " how to make a pilot arc torch work with a THCAD"

Please Log in to join the conversation.

More
6 years 5 months ago #168563 by tommylight
Replied by tommylight on topic Plasma Linuxcnc finally running correctly
Let's see if it sticks!
The subject, that is. :)

Please Log in to join the conversation.

More
6 years 5 months ago #168567 by rodw
Replied by rodw on topic Plasma Linuxcnc finally running correctly
Finally correct(ly)! I have found you need to edit the first post and then edit the last post to change it.

Please Log in to join the conversation.

More
6 years 5 months ago #168584 by jay1st
Replied by jay1st on topic Plasma Linuxcnc finally running correctly
good to know !

Please Log in to join the conversation.

Time to create page: 1.971 seconds
Powered by Kunena Forum