DIY CNC router build

More
5 years 10 months ago #193319 by shpatb
Replied by shpatb on topic DIY CNC router build
Mounted X rails , welded the tube to 4mm plates for more stiffness..
also welded a 5x5 tube under the table to mount the ballscrew.
would have posted a video of me holding on gantry as it would take me for a ride but that would make tommy envy so leave it for some time..:woohoo: :woohoo:

Please Log in to join the conversation.

More
5 years 10 months ago #193320 by tommylight
Replied by tommylight on topic DIY CNC router build
Looking nice ! :)

Please Log in to join the conversation.

More
5 years 10 months ago #193412 by shpatb
Replied by shpatb on topic DIY CNC router build


time has passed ,tommy's envy has gone ..:laugh: :laugh:

enjoy..

Please Log in to join the conversation.

More
5 years 10 months ago #193414 by tommylight
Replied by tommylight on topic DIY CNC router build
Nice ride ! :)

Please Log in to join the conversation.

More
5 years 9 months ago #193870 by shpatb
Replied by shpatb on topic DIY CNC router build
some progress ... :side:

Please Log in to join the conversation.

More
5 years 9 months ago #193878 by tommylight
Replied by tommylight on topic DIY CNC router build
How much was the Kzubr ? What RPM does it do ? Is it to loud ?

Please Log in to join the conversation.

More
5 years 9 months ago #193883 by shpatb
Replied by shpatb on topic DIY CNC router build
25eu to 35 depends how u buy it :woohoo:
runs very quiet , 710watt of power , 35000 r/min , 6mm bore for bits.

Please Log in to join the conversation.

More
5 years 9 months ago #193887 by tommylight
Replied by tommylight on topic DIY CNC router build
Expect an order for two of them soon ! :)

Please Log in to join the conversation.

More
5 years 9 months ago #193999 by Clive S
Replied by Clive S on topic DIY CNC router build

shpatb wrote:



time has passed ,tommy's envy has gone ..:laugh: :laugh:

enjoy..


Stress test:

Please Log in to join the conversation.

More
5 years 9 months ago #194042 by shpatb
Replied by shpatb on topic DIY CNC router build
very nice :laugh: :woohoo:

what steppers are u using ?

Please Log in to join the conversation.

Time to create page: 0.058 seconds
Powered by Kunena Forum