Homemade, cheap, plasma CNC

More
4 years 11 months ago #225961 by rodw
Replied by rodw on topic Homemade, cheap, plasma CNC
Ooops not dd. I used Gparted as it has a GUI

Please Log in to join the conversation.

More
4 years 11 months ago #225967 by tommylight
Replied by tommylight on topic Homemade, cheap, plasma CNC
Noooooooooooo :)
Just zip the folder and copy with a normal USB.
Zip or TAR.GZ will preserve symlinks.

Please Log in to join the conversation.

More
4 years 11 months ago #226303 by RNJFAB
Replied by RNJFAB on topic Homemade, cheap, plasma CNC
Tonights challenge - get a button to turn on/ turn off the laser to sight in the job & load my toolsets from SheetCam into QTPlasmaC.

I'll let you know it goes.

Please Log in to join the conversation.

More
4 years 11 months ago #227139 by RNJFAB
Replied by RNJFAB on topic Homemade, cheap, plasma CNC
Tried every combination that I could from reading a lot of posts, but I'm still unable to turn on an output from a button on the Plasmac GUI.

I'll try and post the combinations I have tried.

Please Log in to join the conversation.

More
4 years 11 months ago #227140 by phillc54
Replied by phillc54 on topic Homemade, cheap, plasma CNC
Posting the code is good, or even your complete ini file.

Is it PlasmaC or QtPlasmaC that you are using.

Please Log in to join the conversation.

More
4 years 11 months ago #227141 by RNJFAB
Replied by RNJFAB on topic Homemade, cheap, plasma CNC
Hey Phillc54,

Upgraded to QtPlasmaC.

Please Log in to join the conversation.

More
4 years 11 months ago #227142 by phillc54
Replied by phillc54 on topic Homemade, cheap, plasma CNC
Cool, your last post mentioned PlasmaC and that does the buttons a little bit differently than QtPlasmaC, we probably should have called it something that would be a bit less confusing. Anyhow it is what it is now ...

Please Log in to join the conversation.

More
4 years 11 months ago #227143 by rodw
Replied by rodw on topic Homemade, cheap, plasma CNC
try something like
Code:
net laser:switch qtplasmac.laser_on => my-mesa-output-pin

Please Log in to join the conversation.

More
4 years 11 months ago #227145 by RNJFAB
Replied by RNJFAB on topic Homemade, cheap, plasma CNC
 

Attachment not found

 

Attachment not found

 

Attachment not found



Still no dice. 

Please Log in to join the conversation.

More
4 years 11 months ago #227148 by rodw
Replied by rodw on topic Homemade, cheap, plasma CNC

 

Attachment not found

 

Attachment not found

 

Attachment not found



Still no dice. 
not what I said. you have created a signal but its not connected to anything . Try
Code:
net plasmac:laser-switch qtplasmac.laser_on => hm2_7i96.0.ssr.00.out-01

Please Log in to join the conversation.

Time to create page: 0.191 seconds
Powered by Kunena Forum