Another QTPlasmaC machine done.

bevins
Topic Author
Offline
Platinum Member

4 years 11 months ago #225979 by bevins

Another QTPlasmaC machine done. was created by bevins

This one is using a ProCut-55 QTPlasmac with mesa thcad-10 THC and mesa 7i92/7i76 setup.

Attachment not found

Please Log in to join the conversation.

bevins
Topic Author
Offline
Platinum Member

4 years 11 months ago #225983 by bevins

Replied by bevins on topic Another QTPlasmaC machine done.

I need to speed up the probing, and it goes too high between cutting. This can be done in the settings in the gui?

Please Log in to join the conversation.

tommylight
Offline
Administrator

4 years 11 months ago #225997 by tommylight

Replied by tommylight on topic Another QTPlasmaC machine done.

Setup speed, probe speed, probe height, safe height.
Very nice as usual, but i would like to complain = to big of a gantry, to complicated, to much time building it.

Very nice use of a manual torch!

Please Log in to join the conversation.

bevins
Topic Author
Offline
Platinum Member

4 years 11 months ago #226008 by bevins

Replied by bevins on topic Another QTPlasmaC machine done.

The gantry and base was purchased by the customer for 150.00. We did everything else.

Please Log in to join the conversation.

tommylight
Offline
Administrator

4 years 11 months ago #226009 by tommylight

Replied by tommylight on topic Another QTPlasmaC machine done.

Oh, that is to cheap to complain about !

Please Log in to join the conversation.

bevins
Topic Author
Offline
Platinum Member

4 years 11 months ago #226275 by bevins

Replied by bevins on topic Another QTPlasmaC machine done.

some more Plasma candy....

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.114 seconds