Arduino IO Expansion

i put that. it just waits for something.
 

Edit: i got it. Just rename the file from arduino-connector to arduino with loadusr -W arduino and it works.

I'm trying to use LinuxCNC_ArduinoConnector V2, but it's not very clear how to install this new version. I initially used install.sh, then loadusr arduino-connector, but an error appears. I included the instructions in the hal and ini files, but nothing happens when I run linuxcnc.

Sekai wrote:

Edit: i got it. Just rename the file from arduino-connector to arduino with loadusr -W arduino and it works.
 

Yes, it works, but is not solution.
I remember that program name must be the same as component name, so if component is "arduino" the program must be "arduino" too.
But "arduino" is bad name, because is widely used for many things, so it should be renamed to unique one.