EtherCAT RC Servo Motor & PWM Output Interface Board

– ETHERCAT RC SERVO MOTOR INTERFACE
– 4x RC SERVO MOTOR CAN BE CONNECTED SAME TIME
– 24VDC SUPPLY
www.egerobotics.com/ethercat-pwm-rc-servo-interface

No triple posting.
Two posts with the same contents were deleted.
Thank you.

there was no "same content"
every 3 boards are different

emresensoy wrote:

there was no "same content"
every 3 boards are different

Oh cr@P!
Sorry, can you please upload them again.
And what did i miss?
Again, i am really sorry for the mess, they did seem the same form a quick glance and the tittles were very similar.

Where do you see this board being used?
Haven't seen much use for RC servos in linuxcnc.
Is it in robotics maybe?

I don't actually know where it's used. However, this board essentially has open-collector PWM outputs. It could be used in PWM-controlled proportional valves, etc., and other components.

As you mentioned, an RC servo motor could offer a fast way to mechanically implement LinuxCNC's powerful robotic infrastructure.