Profile for arhi

Offline

User Type: User
Rank: Senior Member

Register Date: 01 May 2016
Last login: 7 years 9 months ago
Time Zone: UTC +1:00
Local Time: 19:04

Posts: 54
Profile views: 3

Gender: Unknown
Birthdate: Unknown

arhi's recent posts (54 messages )

	Subject	Replies / Views	Last Post

	learning from mesa design :) Category: Driver Boards Topic started 7 years 9 months ago, by arhi Last Post 7 years 9 months ago by arhi	Replies:4 Views:1807	Last Post by arhi 7 years 9 months ago
	learning from mesa design :) Category: Driver Boards Topic started 7 years 9 months ago, by arhi Last Post 7 years 9 months ago by arhi	Replies:4 Views:1807	Last Post by arhi 7 years 9 months ago
	learning from mesa design :) Category: Driver Boards Topic started 7 years 9 months ago, by arhi Last Post 7 years 9 months ago by arhi	Replies:4 Views:1807	Last Post by arhi 7 years 9 months ago
	MESA boards - schematic, especially 7i80HD-25 but any eth enabled one really Category: Driver Boards Topic started 9 years 5 months ago, by arhi Last Post 9 years 5 months ago by arhi	Replies:2 Views:1896	Last Post by arhi 9 years 5 months ago
	MESA boards - schematic, especially 7i80HD-25 but any eth enabled one really Category: Driver Boards Topic started 9 years 5 months ago, by arhi Last Post 9 years 5 months ago by arhi	Replies:2 Views:1896	Last Post by arhi 9 years 5 months ago
	7I80HD-25 - missing files (PIN_*.vhd) Category: Driver Boards Topic started 9 years 5 months ago, by arhi Last Post 9 years 5 months ago by arhi	Replies:2 Views:1539	Last Post by arhi 9 years 5 months ago
	7I80HD-25 - missing files (PIN_*.vhd) Category: Driver Boards Topic started 9 years 5 months ago, by arhi Last Post 9 years 5 months ago by arhi	Replies:2 Views:1539	Last Post by arhi 9 years 5 months ago
	hw stepper card, linuxcnc, top view?! Category: General LinuxCNC Questions Topic started 10 years 4 months ago, by arhi Last Post 10 years 4 months ago by arhi 1 2	Replies:11 Views:4937	Last Post by arhi 10 years 4 months ago
	hw stepper card, linuxcnc, top view?! Category: General LinuxCNC Questions Topic started 10 years 4 months ago, by arhi Last Post 10 years 4 months ago by arhi 1 2	Replies:11 Views:4937	Last Post by arhi 10 years 4 months ago
	RTAPI: ERROR: Unexpected realtime delay on task 1 Category: General LinuxCNC Questions Topic started 10 years 4 months ago, by arhi Last Post 10 years 4 months ago by arhi 1 2	Replies:14 Views:7419	Last Post by arhi 10 years 4 months ago

Time to create page: 4.938 seconds

Powered by Kunena Forum