Profile for spumco

Offline

User Type: User
Rank: Platinum Member

Register Date: 02 Feb 2021
Last login: 5 days 20 hours ago
Time Zone: UTC +0:00
Local Time: 08:54

Posts: 2180
Profile views: 13

Gender: Unknown
Birthdate: Unknown

spumco's recent posts (2180 messages )

	Subject	Replies / Views	Last Post

	Looking for an older CNC mill to refurbish/retrofit Category: General LinuxCNC Questions Topic started 1 month 14 hours ago, by NoSmoke Last Post 3 weeks 4 days ago by Todd Zuercher	Replies:9 Views:438	Last Post by Todd Zuercher 3 weeks 4 days ago
	Looking for an older CNC mill to refurbish/retrofit Category: General LinuxCNC Questions Topic started 1 month 14 hours ago, by NoSmoke Last Post 3 weeks 4 days ago by Todd Zuercher	Replies:9 Views:438	Last Post by Todd Zuercher 3 weeks 4 days ago
	New LinuxCNC Multi-Channel System – Looking for Testers & Feedback Category: Show Your Stuff Topic started 4 weeks 1 day ago, by retrofitcenter Last Post 5 days 6 hours ago by retrofitcenter 1 2 3	Replies:25 Views:1627	Last Post by retrofitcenter 5 days 6 hours ago
	Looking for an older CNC mill to refurbish/retrofit Category: General LinuxCNC Questions Topic started 1 month 14 hours ago, by NoSmoke Last Post 3 weeks 4 days ago by Todd Zuercher	Replies:9 Views:438	Last Post by Todd Zuercher 3 weeks 4 days ago
	New LinuxCNC Multi-Channel System – Looking for Testers & Feedback Category: Show Your Stuff Topic started 4 weeks 1 day ago, by retrofitcenter Last Post 5 days 6 hours ago by retrofitcenter 1 2 3	Replies:25 Views:1627	Last Post by retrofitcenter 5 days 6 hours ago
	New LinuxCNC Multi-Channel System – Looking for Testers & Feedback Category: Show Your Stuff Topic started 4 weeks 1 day ago, by retrofitcenter Last Post 5 days 6 hours ago by retrofitcenter 1 2 3	Replies:25 Views:1627	Last Post by retrofitcenter 5 days 6 hours ago
	Would you use a feed rate for rotary axes in mm/min (surface speed)? Category: General LinuxCNC Questions Topic started 1 month 1 day ago, by grandixximo Last Post 3 weeks 6 days ago by scotth 1 2	Replies:19 Views:832	Last Post by scotth 3 weeks 6 days ago
	Would you use a feed rate for rotary axes in mm/min (surface speed)? Category: General LinuxCNC Questions Topic started 1 month 1 day ago, by grandixximo Last Post 3 weeks 6 days ago by scotth 1 2	Replies:19 Views:832	Last Post by scotth 3 weeks 6 days ago
	Would you use a feed rate for rotary axes in mm/min (surface speed)? Category: General LinuxCNC Questions Topic started 1 month 1 day ago, by grandixximo Last Post 3 weeks 6 days ago by scotth 1 2	Replies:19 Views:832	Last Post by scotth 3 weeks 6 days ago
	Faceting/Linearization leading to poor surface finish Category: PathPilot Topic started 4 years 11 months ago, by mach-chris Last Post 1 month 4 days ago by spumco 1 2 3	Replies:29 Views:7025	Last Post by spumco 1 month 4 days ago

Time to create page: 0.236 seconds

Powered by Kunena Forum