to TTS, or not to TTS, that is the question......

Sent you an email with the full list, check junk if you don't see it.

-Ralph

You can get "end mill holders" on eBay relatively cheaply. You can get Weldon flat end mills that are designed to clamp in these holders. You get repeatable tool lengths with these.  Just leave the cutter in the holder.
I use a lot of small solid carbide end mills (1/8" and 1/4") and these work fine in the end mill holders even though they don't have the flat. I stopped using R-8 collets a long time ago.
Jon

Haven't heard back from you on the TTS holders, either here or via the email address you sent.

You still want some or all?

Anyone else?

I’d be interested in perusing the list. 
 

Will do. I'd be happy to post the list here, but I don't know the rules about that.

It looks like it would be OK in User Exchange section:

forum.linuxcnc.org/54-user-exchange