Remora - ethernet NVEM / EC300 / EC500 cnc board

What exactly do you need help with?

ww1.microchip.com/downloads/en/DeviceDoc/8720a.pdf

You can follow the traces to make a schematic.

I have NXP calling me about the i.MX RT1050's.

Bari wrote:

What exactly do you need help with?

ww1.microchip.com/downloads/en/DeviceDoc/8720a.pdf

You can follow the traces to make a schematic.

I have NXP calling me about the i.MX RT1050's.

Schematic is traced, it's now about getting a PHY driver working...

github.com/ARM-software/CMSIS-Driver/tree/main/ETH

www.oryx-embedded.com/doc/lan8720__driver_8c.html

community.nxp.com/t5/i-MX-RT-Knowledge-B...XRT1050/ta-p/1107482

A huge thanks that have helped support on GoFundMe, it won't be in vain. Ethernet is working!!! image missing /media/kunena/emoticons/cheerful.png

This has been a lot of research and even some "help" from NXP. I could not get a C++ project to work, however when I started with an SDK ping example (C code) modified to run on the Novusun board, success. 

And now success converting that project into a C++ code base, with the board happily replying to ping requests.

I think the most challenging parts of the porting of Remora to the RT1052 are now done (I hope). 

 

Hello. How do I upload the configuration file to the Nvem v2 board? And then how do I run it in linuxcnc? well thank you

Hi, this thread is long but the topic is covered here. May be easier to check out these videos.