New User-EMC2 Splash Z Home=2.4?
- Highlander01
- Offline
- Junior Member
-
Less
More
- Posts: 21
- Thank you received: 0
11 Jan 2010 23:56 #1494
by Highlander01
New User-EMC2 Splash Z Home=2.4? was created by Highlander01
I am a new user.
I am playing with running the "EMC2 AXIS" Splash GCode.
I set up my "step config wizard" and x y and z all have 0 home positions.
When I do EMC2 manual set up I manually move motors/axis to home positions and set home by clicking home position button.
X and Y go to zero. For some reason Z goes to 2.4 or some offset of it no matter what I do in do in the "step config wizard".
Is this something coded in the GCode or some where else that overides the zero I set up in "step config wizard"?
I have some GCode learning to do.
I am playing with running the "EMC2 AXIS" Splash GCode.
I set up my "step config wizard" and x y and z all have 0 home positions.
When I do EMC2 manual set up I manually move motors/axis to home positions and set home by clicking home position button.
X and Y go to zero. For some reason Z goes to 2.4 or some offset of it no matter what I do in do in the "step config wizard".
Is this something coded in the GCode or some where else that overides the zero I set up in "step config wizard"?
I have some GCode learning to do.
Please Log in or Create an account to join the conversation.
12 Jan 2010 12:46 #1499
by BigJohnT
Replied by BigJohnT on topic Re:New User-EMC2 Splash Z Home=2.4?
You have an offset stored from a previous file that you ran.
www.linuxcnc.org/docview/html//gcode_mai...ub:G92,-G92.1,-G92.2,
John
www.linuxcnc.org/docview/html//gcode_mai...ub:G92,-G92.1,-G92.2,
John
Please Log in or Create an account to join the conversation.
Time to create page: 0.062 seconds