Get axis to show current executing line?

I was watching axis scroll the current program by, and then I clicked in the window by accident. Now it's not scrolling any more, and I can't figure out how to get it to resume doing that.

Hi,

For a while i use the qtaxis config. You could step over to this newer version. It's nicer. No stacked error message's and scrolling works oke.

I have noticed before and its annoying, I just found that if you double click the greyed out stationary line(selected_line), it will resume following the running line (release_selected_line)

Grotius wrote: Hi,

For a while i use the qtaxis config. You could step over to this newer version. It's nicer. No stacked error message's and scrolling works oke.

Can you explain what you mean by this? I have no idea what qtaxis is.

JetForMe wrote:

Grotius wrote: Hi,

For a while i use the qtaxis config. You could step over to this newer version. It's nicer. No stacked error message's and scrolling works oke.

Can you explain what you mean by this? I have no idea what qtaxis is.

See Figure 3: linuxcnc.org/docs/2.8/html/gui/qtvcp.html#_overview

Just double-click the program window, and the scrolling will start again.

A bit late for answering, but I think it could help somebody like me