Manual mode AXS
19 Dec 2023 20:29 #288614
by tomala89
Manual mode AXS was created by tomala89
Is it possible to set AXIS to automatically change manual mode to automatic mode when the axis is moved in any direction after pressing the arrow key?
Thanks
Thanks
Please Log in or Create an account to join the conversation.
23 Dec 2023 10:03 #288878
by andypugh
Replied by andypugh on topic Manual mode AXS
This _might_ be possible using tha .axisrc file.
There is a thread on this forum about Axis modifications, which might provide some clues.
forum.linuxcnc.org/21-axis/29735-axis-modifications
There is a thread on this forum about Axis modifications, which might provide some clues.
forum.linuxcnc.org/21-axis/29735-axis-modifications
Please Log in or Create an account to join the conversation.
Time to create page: 0.123 seconds