feed convertion
25 May 2011 19:56 #10070
by BigJohnT
Replied by BigJohnT on topic Re:feed convertionwas looking for a combined feed
I'm not sure what your seeing but motion.current-velocity should not show offsets... maybe some other code you have is adding to it. I watched motion.current-velocity and set all kind of offset and it still showed 0.
John
John
Please Log in or Create an account to join the conversation.
25 May 2011 20:27 #10073
by piasdom
Replied by piasdom on topic Re:feed convertionwas looking for a combined feed
i may be wrong about this. when axis plot has zero, i think my panel
is showing command postion. which should be 1/8" off axis plot ?
is showing command postion. which should be 1/8" off axis plot ?
Please Log in or Create an account to join the conversation.
02 Jun 2011 11:42 - 02 Jun 2011 11:45 #10260
by piasdom
Replied by piasdom on topic Re:feed convertionwas looking for a combined feed
Last edit: 02 Jun 2011 11:45 by piasdom.
Please Log in or Create an account to join the conversation.
02 Jun 2011 11:45 - 02 Jun 2011 11:46 #10261
by piasdom
Replied by piasdom on topic Re:feed convertionwas looking for a combined feed
Last edit: 02 Jun 2011 11:46 by piasdom.
Please Log in or Create an account to join the conversation.
02 Jun 2011 11:52 #10262
by BigJohnT
Replied by BigJohnT on topic Re:feed convertionwas looking for a combined feed
Press the # key to toggle the Axis DRO display and see what you get...
John
John
Please Log in or Create an account to join the conversation.
02 Jun 2011 12:06 - 02 Jun 2011 12:29 #10265
by piasdom
Replied by piasdom on topic Re:feed convertion was looking for a combined feed
it switches between relative position and machine position.
i like relative because when i have offset(g10..g55), it show the relative(no offset = 0)
machine position shows the offset(offset = 1.9) and moves from there.
first way - g0 x1 y1 x and y move to 1
second - g0 x1 y1(g54 = 1.9) x moves to 2.9 and y move to 1
in the pic, z is suppose to be at -1.07. in axis that's what shown.
pyvcp panel shows .055. i would like to have a dro as in axis.
if that is possible.
i like relative because when i have offset(g10..g55), it show the relative(no offset = 0)
machine position shows the offset(offset = 1.9) and moves from there.
first way - g0 x1 y1 x and y move to 1
second - g0 x1 y1(g54 = 1.9) x moves to 2.9 and y move to 1
in the pic, z is suppose to be at -1.07. in axis that's what shown.
pyvcp panel shows .055. i would like to have a dro as in axis.
if that is possible.
Last edit: 02 Jun 2011 12:29 by piasdom.
Please Log in or Create an account to join the conversation.
Time to create page: 0.108 seconds