feed convertion

i think i need to change the xpos-cmd signal.
this just gives me x movement. can't see what pin
i'm using besides the one i made in hal and pyvcp.
wha do i use halui.,axis.0

net xpos-cmd ddt.0.in
net X-IPS mult2.0.in0 <= ddt.0.out
net X-ABS abs.0.in <= mult2.0.out
net X-IPM abs.0.out pyvcp.feed-rate

when i change it to this. error 'xpos-cmd can not add... already out pin axis.0.motor.pos.cmd. don't know
where i used that pin axis.0. isn't xpos-cmd not the signal name ? can't see where
i used axis.0.motor.pos.cmd

net xpos-cmd ddt.0.in motion.current-vel
net X-IPS mult2.0.in0 <= ddt.0.out
net X-ABS abs.0.in <= mult2.0.out
net X-IPM abs.0.out pyvcp.feed-rate

Thanks. i found that on the net and thought it was all part of
the function. so adding 60 to the end of "any" setp will
multiply that function by that number?

and do they have a pin/signal that will show how
much time remains for a program to run ?

p.s. know about when emc2.5 will be out ?
been playing with glade. i'm thinking pyvcp
will be easier for me

what other pin besides motion.current-vel do i use? i moved val on zero,one and two.
even but all three ins' together(changed output to .577). how do i get it to be by
multiplied by 60. i use setp but no effect. this shows .333, what i have in my ini.


net feed-zero hypot.0.in0
net feed-one hypot.0.in1
net feed-two hypot.0.in0 motion.current-vel
net feed-output hypot.0.out pyvcp.feed-rate


want to work on hypot and scale. but one at time.