HAL for Pokey57
08 Jun 2021 10:46 #211494
by charlieLedezma
HAL for Pokey57 was created by charlieLedezma
Hi Everyone
Last year wrote asking for help to configure a Pokey Motion Controller, but sadly I didn´t get answer. This time, I wish than one kind soul (
) can share a .hal configuration with me. I am getting run the pokey properly, but my knowledge in Linuxcnc is pretty poor. Please help me and sorry with my English
Last year wrote asking for help to configure a Pokey Motion Controller, but sadly I didn´t get answer. This time, I wish than one kind soul (
) can share a .hal configuration with me. I am getting run the pokey properly, but my knowledge in Linuxcnc is pretty poor. Please help me and sorry with my English Please Log in or Create an account to join the conversation.
Time to create page: 0.042 seconds