Ditching Mach 3/4 LinuxCNC is The Plan!

Played around this morning for a bit,

You can get to the desktop just cancel out of the controller and use the Left ALT + SHIFT at the tormach screen on reboot.

That is as far as I have gotten, have to go to work! Will play more when i get home. I will try and figure out how to get it to boot and bypass the mesa card check and work from LPT port.





Why is post Locked from Replies?

Got My Mesa Cards! Will be rewiring next week.

Got busy was not able to wire it up possibly this weekend, but I forgot to order my wire. Will Still play a bit.

Contract_Pilot,

How's your project going now? Any lucky w/the new Mesa boards?

did you see my tutorial notes about changing how pathpilot boots etc ?

Have been very busy. I have not had much time to work on it. I am hoping to get some time next weekend.