Hal for Lathe?

  • Holzwurm56
  • Topic Author
  • Offline
  • Elite Member
  • Elite Member
More
2 years 7 months ago - 2 years 7 months ago #295825 by Holzwurm56
Hal for Lathe? was created by Holzwurm56
I get a Mesa 7I96 and want to control a lathe. Mainspindle with gearbox, only switch turn on and turn off. Two mpgs for x and z-axis,
all endswitchs on one input. Feed with two dc-servos with step and direction input. Does someone use a lathe with the same
configuration? Would someone be so kind and give me their hal and ini file?
Thanks
Hans
Last edit: 2 years 7 months ago by Holzwurm56.

Please Log in or Create an account to join the conversation.

  • Sergiy_J_S_Automatic
  • Offline
  • New Member
  • New Member
More
2 years 7 months ago #295911 by Sergiy_J_S_Automatic
Replied by Sergiy_J_S_Automatic on topic Hal for Lathe?
Hello. Take it from the first message in this thread.
forum.linuxcnc.org/26-turning/51945-spin...tion-with-mesa-7i96s

Please Log in or Create an account to join the conversation.

Time to create page: 0.057 seconds
Powered by Kunena Forum