Separate encoder or encoder output from servo driver.
- Jdolecki
- Offline
- Senior Member
-
Less
More
- Posts: 44
- Thank you received: 12
02 May 2025 19:13 #327529
by Jdolecki
Separate encoder or encoder output from servo driver. was created by Jdolecki
Originally my lathe had an encoder attached to the spindle head.
My new spindle motor servo driver has an encoder output. Servo is geared 1to1 with the spindle.
I’m assuming that will be enough fore position control.
I using a 7i96 board.
My new spindle motor servo driver has an encoder output. Servo is geared 1to1 with the spindle.
I’m assuming that will be enough fore position control.
I using a 7i96 board.
Please Log in or Create an account to join the conversation.
- andypugh
-
- Away
- Moderator
-
Less
More
- Posts: 23315
- Thank you received: 4945
02 May 2025 19:15 #327531
by andypugh
Replied by andypugh on topic Separate encoder or encoder output from servo driver.
Yes, that should work fine.
Please Log in or Create an account to join the conversation.
Moderators: piasdom
Time to create page: 0.058 seconds