Forum Menu

Arduino Mega as panel interface

More
3 years 11 months ago #256370 by thewho
Replied by thewho on topic Arduino Mega as panel interface
Interesting, but not in stock..

Please Log in or Create an account to join the conversation.

More
3 years 11 months ago #256371 by PCW
Replied by PCW on topic Arduino Mega as panel interface
A 7I90HD is one possibility (72 I/O pins) no analog though.

Please Log in or Create an account to join the conversation.

More
3 years 10 months ago #259438 by HansU
Replied by HansU on topic Arduino Mega as panel interface
How far is the 7i90HD supported in LinuxCNC?
If supported, it would be good if this card would also shows in the categorie "Remote Serial Daughter Cards" in the Mesa shop.

Please Log in or Create an account to join the conversation.

More
3 years 10 months ago #259475 by PCW
Replied by PCW on topic Arduino Mega as panel interface
Yes, any sserial daughtercard is supported by LinuxCNC
(because sserial cards are self describing to LinuxCNC/HAL)

I added the 7I90HD to the "Remote Serial Daughter Cards" section
The following user(s) said Thank You: tommylight

Please Log in or Create an account to join the conversation.

More
3 years 10 months ago #259500 by HansU
Replied by HansU on topic Arduino Mega as panel interface

Yes, any sserial daughtercard is supported by LinuxCNC
(because sserial cards are self describing to LinuxCNC/HAL)

Nice!
Then I wonder what's the advantage of the 7i69 compared to the 7i90HD.
The 7i90 has more I/O and is cheaper...

I added the 7I90HD to the "Remote Serial Daughter Cards" section

Thanks!
Could also fit into this category: "Anything I/O Cards --> Remote Serial Daughter Cards"
 

Please Log in or Create an account to join the conversation.

Moderators: PCW, jmelson
Time to create page: 0.222 seconds
Powered by Kunena Forum