NVEM V5 RT1052
- CNC_Manni
- Offline
- New Member
-
Less
More
- Posts: 5
- Thank you received: 1
06 Aug 2026 18:10 #348501
by CNC_Manni
NVEM V5 RT1052 was created by CNC_Manni
Hello everyone, could you please help me with the following problem?
Board: NVEM V5 (i.MX RT1052)
Tested firmware versions: remora-rt1052-NVEM-0.2.1.bin, remora-rt1052-0.0.1.bin, remora-rt1052.bin — all show identical behaviour
Ping to 10.10.10.10 works fine
upload_config.py sends a WRQ request on port 69 correctly (confirmed via tcpdump), but never receives a response from the board
No firewall active (iptables ACCEPT), direct connection without a router
Is there a special procedure needed to enable TFTP config upload on this board (short a pin, send a command first, etc.)?
Thanks a lot in advance!
Board: NVEM V5 (i.MX RT1052)
Tested firmware versions: remora-rt1052-NVEM-0.2.1.bin, remora-rt1052-0.0.1.bin, remora-rt1052.bin — all show identical behaviour
Ping to 10.10.10.10 works fine
upload_config.py sends a WRQ request on port 69 correctly (confirmed via tcpdump), but never receives a response from the board
No firewall active (iptables ACCEPT), direct connection without a router
Is there a special procedure needed to enable TFTP config upload on this board (short a pin, send a command first, etc.)?
Thanks a lot in advance!
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 21779
- Thank you received: 7442
06 Aug 2026 23:38 #348511
by tommylight
Replied by tommylight on topic NVEM V5 RT1052
This is a duplicate of this topic but in German language.
forum.linuxcnc.org/42-deutsch/59075-nvem-v5-rt1052#348502
forum.linuxcnc.org/42-deutsch/59075-nvem-v5-rt1052#348502
Please Log in or Create an account to join the conversation.
Moderators: PCW, jmelson
Time to create page: 0.147 seconds