MasterCam

For sure you can ...

Only I'm not sure if it has " a good quality level" so it makes sence on the wiki.
If you can judge ... feel free anytime

This postprocessor for Mastercam X9 (3-axis) - LinuxCNC is still "work in progress", use with caution.
I have to adjust the use of subprograms and I must say that it does very well its job, it allows you to use all the LinuxCNC work offssets.
Any suggestion is welcome...

Recently I noticed that linuxcnc 2.8 master supports the G52 offsets which was a long awaited and very useful feature.
Guys, could anyone show me how to implement G52 in the Mastercam postprocessor for linuxcnc, any advice will be welcome.

image missing http://i.imgur.com/cWG8u4P.png

Below I added my mastercam post with subprograms and linuxcnc offsets.