5i25 not reflecting in the PNCCONF
- CNCSREEDHAR2016
- Offline
- New Member
-
Less
More
- Posts: 6
- Thank you received: 0
08 Feb 2016 16:57 #69773
by CNCSREEDHAR2016
5i25 not reflecting in the PNCCONF was created by CNCSREEDHAR2016
HII,
I tried installing a Linux CNC. Whilst settting up the PNCCONF, I could not find the 5i25 for selection. But I had still not mounted this board onto the Motherboard PCI slot yet.
So is it necessary that this board be mounted prior to the set up. Please advice
I tried installing a Linux CNC. Whilst settting up the PNCCONF, I could not find the 5i25 for selection. But I had still not mounted this board onto the Motherboard PCI slot yet.
So is it necessary that this board be mounted prior to the set up. Please advice
Please Log in or Create an account to join the conversation.
08 Feb 2016 17:10 #69774
by andypugh
Replied by andypugh on topic 5i25 not reflecting in the PNCCONF
No, you can use pncconf before you have even bought the hardware. It does no card checking or enumeration (at the moment, at least, as far as I know)
Please Log in or Create an account to join the conversation.
09 Feb 2016 06:35 #69824
by cmorley
Replied by cmorley on topic 5i25 not reflecting in the PNCCONF
In the 2.7.x version of linuxcnc pncconf should show 5i25-internal data
Hopefully one of those firmwares is what your card is programmed to.
No released version of pncconf actually checks for cards - i have a version that does but needs some thought on ease of use.
Chris M
Hopefully one of those firmwares is what your card is programmed to.
No released version of pncconf actually checks for cards - i have a version that does but needs some thought on ease of use.
Chris M
Please Log in or Create an account to join the conversation.
Moderators: cmorley
Time to create page: 0.061 seconds