Linear tool rack with mesa 5i20
28 Feb 2017 06:55 #88719
by Zig
Linear tool rack with mesa 5i20 was created by Zig
Would like to set up a series of tool stations in a linear fashion along the side of the work platen of an engraving machine.
Spindle has pneumatically activated collet. Tool shank standard one eighth of an inch.
Tool overall length fairly consistent 38mm
Hints ... nudges.. kicks in the bum towards setting up the hal file to achieve this welcome.
Spindle has pneumatically activated collet. Tool shank standard one eighth of an inch.
Tool overall length fairly consistent 38mm
Hints ... nudges.. kicks in the bum towards setting up the hal file to achieve this welcome.
Please Log in or Create an account to join the conversation.
28 Feb 2017 16:51 #88747
by andypugh
Replied by andypugh on topic Linear tool rack with mesa 5i20
Have a look at the rack toolchanger sample config in the sim/axis/remap section.
Please Log in or Create an account to join the conversation.
Moderators: cmorley
Time to create page: 0.063 seconds