Dumb question - starting PnCConf with Lcnc RIP

Start
Prev
1
Next
End

spumco
Away
Platinum Member

22 Dec 2021 17:39 #229749 by spumco

Dumb question - starting PnCConf with Lcnc RIP was created by spumco

So I've got 2.9 RIP installed and need to set up a basic configuration with a new Mesa board. I switched from a 7i73 to a 7i84D and want/need to 'start fresh'.

Problem is with the RIP installation I don't have an LCNC menu; I start LCNC from the command line.

How do I run PnCConfig with no menu?

Thx,
R

Please Log in or Create an account to join the conversation.

phillc54
Offline
Moderator

22 Dec 2021 22:50 #229773 by phillc54

Replied by phillc54 on topic Dumb question - starting PnCConf with Lcnc RIP

You first need to set the environment with:

. ~/linuxcnc-dev/scripts/rip-environment

Then start PnCconf with:

pncconf

The following user(s) said Thank You: spumco

Please Log in or Create an account to join the conversation.

spumco
Away
Platinum Member

23 Dec 2021 01:13 #229784 by spumco

Replied by spumco on topic Dumb question - starting PnCConf with Lcnc RIP

Thanks Phill! That did the trick.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Moderators: cmorley

Time to create page: 0.116 seconds