Gscreen - a GTK / Glade / Python based screen

I'm not sure how long ago you pulled..
I added a setting for spindle start rpm on the preference page. This is the rpm that the spindle will automatically start at when you first push the + button. ( of course you can directly enter an RPM using the set-rpm button and the entry widget)
It's not a minimum setting as you can use the - button to lower the RPM down to 100. This is an internal linuxcnc setting.
I could add a minimum preference and an increment preference ( keeping in mind this is just in manual mode)

I will push the mode button changes in a moment...

oops what would 9999 RPM b enough?

Ok I pushed the mode button text and raised the entry widget to 10000 and the preference spinbox to 10000

spindle button (in manual mode) allows you to select a direction and speed. using the fwd/rev buttons then the +- keys
After you pick a direction you can also directly enter the speed you want by entering it in the entry widget and pressing set-RPM

The vertical side buttons are fairly generic - by selecting an axis or spindle allows you to do specific things with the +- buttons for instance

In the other modes (MDI and Auto) I should de-sensitize the spindle button I guess.

Chris

Hi Chris,

the changes are looking good. I am frantically wiring things up so I can use this for real.

This is what the unmodified Gscreen displayed like



You can see the "G Codes Active" make a long line that pushes the right hand side of the screen out of view.

What I changed was the "width in characters" of that box. probably not the correct way of fixing it but it worked



Maybe I have something else set wrong if no one else is having these problems. I am using metric units if that makes a difference.
Thanks for the ongoing efforts.

Jayson.