Axis test OK but only Y-axe is working
- dirver
-
Topic Author
- Visitor
-
12 Jun 2024 20:01 #302900
by dirver
Axis test OK but only Y-axe is working was created by dirver
Dear all,I'm new with Linuxcnc and installed the latest version.Stepconf wizard runs OK, including all axis.But when I want to move all the axis in Linuxcnc only the Y-axe moves, the other axis do nothing.Any idea ?Regards,Dirk
Attachments:
Please Log in or Create an account to join the conversation.
- tommylight
-
- Away
- Moderator
-
Less
More
- Posts: 20247
- Thank you received: 6886
12 Jun 2024 22:59 #302912
by tommylight
Replied by tommylight on topic Axis test OK but only Y-axe is working
That is very weird pinout for anything, so what is the parallel port attached to?
Please Log in or Create an account to join the conversation.
- dirver
-
Topic Author
- Visitor
-
13 Jun 2024 06:22 #302922
by dirver
Replied by dirver on topic Axis test OK but only Y-axe is working
first (and only) parallelport p0
weird pinouts? This is my first Linuxcnc-installation ever, so I just followed the stepconf-wizard
weird pinouts? This is my first Linuxcnc-installation ever, so I just followed the stepconf-wizard
Please Log in or Create an account to join the conversation.
Time to create page: 0.055 seconds