fresh install issue with 2.9.4

 So I decided to do a fresh install on the computers for my Mill and Lathe. The computers areDell Optiplex 9020 micros. I am installing Linuxcnc V2.9.4 ISO. After installing and then updatingI get an error message ofE: Subprocess /usr/bin/dpkg returned an error code (1)it also says there is an issue with initramfs-tools.all that said I am attaching a pic of the error message to help. I am sure I am missing something stupidI usually do. LOL
   
 

found the problem
I see it is talking about missing raspi-firmware.
to remove enter the terminal
then enter
sudo dpkg -P raspi-firmware
now the error is gone. image missing /media/kunena/emoticons/smile.png
 

This is still dragging on..... bloody hell.
When did you download the ISO?
2025-01-27 is the last upload date.
Whoever is building the image:
Clean the build environment before building a new image!!!
I am tired of repeating this.
But i am sure this was Debian's f@kup so i am cool again!
Debian should never ever have anything RPI related into AMD64 images, they had.
Edit:
And rubber ducky also means something else, so refrain from using it near PC/network security experts

I think I downloaded it a few months ago. I just downloaded another one a few minutes ago.
I will install that one to see if the problem is persisting. I will reply back in a bit when I know
one way or the other.
stand by

Yup still there.
today's download  and install yields this report on terminal
 

after running sudo dpkg -P raspi-firmware
terminal yields this report
 

Sorry tommylight I know it's always something. I will just put a note with
my install disk ( yes I still make disks instead of thumb drives ) LOL

Edit:And rubber ducky also means something else, so refrain from using it near PC/network security experts

UGH. why is it always the most innocent things get turned into something else.