Keyboard Shortcuts in Gmoccapy

Thank you for reply MR. HansU
I try with your link of MR.andypugh .

I: Bus=0003 Vendor=1a2c Product=2124 Version=0110
N: Name="SEM USB Keyboard"
P: Phys=usb-0000:00:14.0-4/input0
S: Sysfs=/devices/pci0000:00/0000:00:14.0/usb2/2-4/2-4:1.0/0003:1A2C:2124.0001/input/input5
U: Uniq= H: Handlers=sysrq kbd leds event5 
B: PROP=0 B: EV=120013
B: KEY=1000000000007 ff800000000007ff febeffdff3cfffff fffffffffffffffe
B: MSC=10 B: LED=7


I create file on /etc/udev/rules.d/

ATTR{idProduct}=="1a2c", ATTR{idVendor}=="2124", MODE="0660", GROUP="asis"  #(I already create group name: asis )

I save, and reboot 1 time
When run linuxcnc , not work ,   just  :hal:27: hal_input exited without becoming ready

Have any more for me set-up ?

Thankyou,
Asis

 

Not sure if this is related but you seem to have a preceding error:

HAL: ERROR: duplicate component name 'iocontrol'

if you comment out the line

loadusr -W hal_input -KRAL SEM

Do you still get the 'iocontrol' error?

Thank you, for fast respond.
when comment (#)
can run linuxcnc
 

Hi
i test this on my Machine and i think your UDEV is wrong.

---

My Inputdevice:
I: Bus=0003 Vendor=04b3 Product=3025 Version=0110
N: Name="LITE-ON Technology USB NetVista Full Width Keyboard."

---

Add this to your UDEV File ---- change the id´s to yours.

ATTRS{idVendor}=="04b3", ATTRS{idProduct}=="3025", GROUP="plugdev" ,MODE="0666"

Then open a Terminal make the following commands... with your naming

sudo adduser cnc plugdev
sudo udevadm trigger
halrun
loadusr -W hal_input -KRAL LITE
after that i get this
note: name is 'LITE-ON Technology USB NetVista Full Width Keyboard.'
halcmd: Note: Using POSIX realtime


I get no more permission warnings.

Here a Video from my testing today.....

youtu.be/aqY-ZunRbHU







Peter

Hi, there,

i am trying to make a keyboard shortcut to toggle between TURTLE and RABBIT jog mode. I think that the code should have look something like this: 

        if keyname == "r":
            "some toggle event goes here"
            return True

It is shown on in the def on_key_event section in the code attached from line 3052. Can you help me which event should I use to toggle jog modes? 

 

PostavCNC wrote:

Hi, there,

i am trying to make a keyboard shortcut to toggle between TURTLE and RABBIT jog mode. I think that the code should have look something like this: 

        if keyname == "r":
            "some toggle event goes here"
            return True

It is shown on in the def on_key_event section in the code attached from line 3052. Can you help me which event should I use to toggle jog modes? 

 

Toggling does not really work without further changes, because it toggles the button twice then.
Adding two buttons is the simplest solution if that works for you.