Forum Menu

Jog keys for A axis

More
2 years 2 months ago #306910 by newbynobi
Replied by newbynobi on topic Jog keys for A axis
Can't you use the gmoccapy Jog hal pin?
  • gmoccapy.jog.jog-A-plus (bit IN)
  • gmoccapy.jog.jog-A-minus (bit IN)

    Norbert

Please Log in or Create an account to join the conversation.

More
2 years 2 months ago #306969 by mariusl
Replied by mariusl on topic Jog keys for A axis
Hi Norbert,
The machine only has a standard keyboard. I am not sure how I would do that?
Regards
Marius


www.bluearccnc.com

Please Log in or Create an account to join the conversation.

More
2 years 2 months ago #307249 by zz912
Replied by zz912 on topic Jog keys for A axis
To Aciera: Can I ask you for Pull Request?
I would also like this improvement.

Please Log in or Create an account to join the conversation.

More
2 years 2 months ago #307250 by mariusl
Replied by mariusl on topic Jog keys for A axis

To Aciera: Can I ask you for Pull Request?
I would also like this improvement.
For at least five (5) axis please but all six will be better.
Regards
Marius


www.bluearccnc.com

Please Log in or Create an account to join the conversation.

More
2 years 2 months ago #307252 by zz912
Replied by zz912 on topic Jog keys for A axis
If Aciera agrees, I can create a Pull Request.

However, it is necessary to define which key letters are to be used.
This must be approved by Norbert.

It will be necessary to test how this change will affect the 3 axis configuration.

Please Log in or Create an account to join the conversation.

More
2 years 2 months ago #307255 by Aciera
Replied by Aciera on topic Jog keys for A axis
I don't use keyboard shortcuts so the changes I posted have been reverted on my local machine. If you are interested to have those changes as a PR then please go ahead.

Please Log in or Create an account to join the conversation.

Moderators: newbynobi, HansU
Time to create page: 0.205 seconds
Powered by Kunena Forum