Punch Press Gcode

Is this the right place to ask my question? If not someone help please to find the appropriate section of this forum

It seems as good a place as any.
But I was away from LinuxCNC machines all weekend.

Thanks andypugh
Waiting for you to get back

I think that the trick is to include "modalgroup=1" in the REMAP line. Removing it certainly prevents remapping from working, despite the system stating that it will use the default of 1.

If you want to put the g11.ngc file in the config directory (which is where I think it belongs) then you should use:
You don't currently seem to be using the XY parameters. When you want to, you will need something like this to deal with the fact that X and Y are both optional;

I got in a bit of a tangle trying to see if G11 / g11 made a difference, and ended up with files of both names in both places,
But I figured that you would prefer to have the answer than have me spend an hour or so going through all possibilities.

Thanks andypugh
I'll try and get back to you

It show an error:
EOF in file (current executed ngc file)
Seeking o-word: o<g11> from line:0

I added your code before my gcode program and it worked very well.
Is this the right way to remap g11, put it's code inside every ngc file?

Note: it worked only with G11 not g11 in the REMAP =G11

AElmasry wrote: I added your code before my gcode program and it worked very well.
Is this the right way to remap g11, put it's code inside every ngc file?

No, you should be able to put g11.ngc in the config directory, and then g11 is a new G-code.

Ok, I'll check whats wrong.
I have another problem that sometimes the interpreter execuete next line before reach the desired position
For example
G11 x1500 y500
M64 p0 ( for punching)
Some times i get the punch at x1499 y500
Or x1500 y 499

How can i hold g1 or g11 till get exact position or not exceeding specific error ( 0.1 mm)

Don't know if this is the answer, but is the machine set for G61.1 mode or the default G64 mode (or G61)?

Also if it is a servo, is the dro set to actual or commanded postion?