XYZAC Kinematic Calibration

Hi everyone,

I am trying to get xyzac working in my machine and for the most part everything seems fine.
When I try to align the z axis with a point (10 cm ~ the same distance as when a fixture is fit on the bed) above my bed and then switch over to xyzac kinematics and jog only the a axis I notice that z and a are not following each other.

How do I begin to calibrate the axis for xyzac mode?

Thanks in advance,
Abhishek

Please see my reply to the same question asked elsewhere:
forum.linuxcnc.org/10-advanced-configura...ics?start=490#263657

And please stop asking the same question in multiple places.

Hi Andy,

Thanks for the Reply..
I waited for the reply over other thread for 3 to 4 days and nobody answered and I thought that the thread might have closed so I started the new thread. Sorry for asking same question in two different places

Regards
Abhishek

This forum does not close threads/topics.
Multiple posts with the same questions makes it impossible to follow what has been answered and what not.