Auto Tool Measurement setup,makes gmoccapy slow and difrent configation,

herre
there are some err with python ?

I see, seems you are trying to run a config from version 2.8 which used python2 on a newer version which requires python 3

You could try to replace the 3 files in the 'remap' folder of your config with the 3 files from here:
github.com/LinuxCNC/linuxcnc/tree/2.9/co.../sim/gmoccapy/python

[edit]
Actually you only need to replace one file stdglue.py

thanks a lot m8,  now it runs normal. 

I'll try it out tomorrow out with the machine,